“The” Cookie Monster

[Weebz]

Ha!   Bring it.  Really wouldn’t be too hard a second time around.  

[Savage90]

What an awesome build! Very impressive taking on something like this by yourself!!
I would love to do the back half kit with outboard coilovers! But I just barely got my EVO lever on and haven’t even gotten my Jeep back to enjoy yet. Haha. 
just dropping into day very nice work!

[Weebz]

Much appreciated!

[Jdofmemi]

Jeff

 

Just curious, what is your measurement in the front left from the bottom of the frame to the top of the axle, at ride height?

 

I'm just trying to compare with where Vengeance is going to end up.

 

 

[Weebz]

Hard to measure if I’m trying to measure to top of axle tube as it’s a slight angle but it’s like 10”

[Weebz]

And I assume you mean driver side by left. 

[Jdofmemi]

1 hour ago, Weebz said:

And I assume you mean driver side by left. 

Yes

 

Straight down from the bottom of the frame to the top of the axle tube 

[Weebz]

Like I said just about 10” then.   Where are you at

[Jdofmemi]

Thanks

 

That is basically the same Vengeance will be at after this round of mods.

 

No more low rider!

 

That said, I will probably flop it at least once as I adjust to the new stance. 

[Jdofmemi]

And, damn me 

 

I missed the double post, only looked at the second one

 

Can't wait to wheel with you again! 

[Weebz]

All good.  Looking forward to it!

[Nice Little Jeep]

On 3/9/2024 at 6:21 PM, Jdofmemi said:

Yes

 

Straight down from the bottom of the frame to the top of the axle tube 

So sitting right there my ride height is 8 1/2 inches, from bottom of frame to top axle.